Anet A8 Mosfet Schaltplan. Anet 3d printer board schematic and board. The heating element that came with the anet a8 will perform ok with an increase of the psu 1 voltage to 14 volts.
Screw these into the connectors on the motherboard. Disconnect the wires from the psu to the mosfet unit and apply them to the second psu. Apply a second mosfet for the extruder.
Unscrew the two wires from the bed connector on the motherboard.
Strip 6mm of insulation from the unterminated ends of the control cable. Unscrew the two wires from the bed connector on the motherboard. However its control board has a reputation for not being as reliable as it should be. Apply a second mosfet for the extruder.
